Tuners

87.5MHz - 108.0MHz

tuning range

MW	531kHz - 1602kHz (E/UK) 530 - 1710 kHz (N)
LW	144kHz - 288kHz

25kHz (manual)
50kHz (scan) (E/UK)
100kHz (scan) (N)

tuning steps

MW	9kHz (E/UK) 10kHz (N)
LW	1kHz

(50dB IHF) mono
12.5dBµV (or 23.5dBf)
(50dB IHF) stereo
33.5dBµV (or 44.5dBf)

sensitivity

MW	(for 20dB signal to noise) 600µV. m^-1
LW	(for 20dB signal to noise) 800µV. m^-1

20Hz - 15kHz
(± 1.0dB)

frequency response

MW/ LW

45Hz - 4.2kHz (IF wide)
45Hz - 800Hz (IF narrow)
(± 1.5dB)

(IHF) alternate channel
greater than 65dB (IF narrow)
greater than 40dB (IF wide)

selectivity

greater than 50dB ± 9kHz
(± 10kHz, N)

(1kHz) 50dB)

stereo separation

N/A

(stereo, IF wide 1kHz) less than 0.08%

total harmonic distortion

less than 0.5% (30% modulation, 1kHz)

(IF wide, 40kHz deviation) typically 1dB (IHF)

capture radio

N/A

greater than 60dB (IHF)

am suppression

N/A

greater than 80dB at 19kHz

pilot tone rejection

N/A

(mono) greater than 76dB IHF
(for greater than 46dBµV or 57dBf)
(stereo) greater than 72dB IHF
(for greater than 64dBµV or 75dBf)

ultimate signal to noise

greater than 54dB

37.5kHz deviation

calibration level
(-6dB peak level)

50% modulation

50µs or 75µs
according to country

de-emphasis

N/A

75Ω

antenna connection

N/A

image greater than 70dB
IF greater than 80dB
IF/ 2 greater than 80dB

spurious response

IF typically 50dB

DAB Section (option)	frequency range	(L band) 1452MHz - 1492MHz (band III) 174MHz - 240MHz
	DAB modes	mode I, II, III, IV (ETS 300 401)
	data converter	24-bit, 48kHz, 128-times over-sampling, multi-bit delta sigma DAC
	antenna connection	50Ω BNC
general	calibration frequency	400Hz nominal
	audio output impedance	100Ω nominal
	output level (full modulation)	1.3Vrms ±1dB
	audio output connector	phone sockets
	digital output (option)	phono socket – coaxial, SPDIF BNC socket – coaxial, SPDIF TOSLINK™ – optical, EIAJ RC- 5720
	data output (option)	TOSLINK™ – optical, EIAJ RC- 5720

digital output impedance

75Ω ±10%

digital output level
(into rated load)

500mVpp ±10% (75Ω load)

operating temperature range

10 - 35°C

ac supply frequency

50 – 60Hz

ac supply voltage

110 – 120V or 220 – 240V
The voltage is marked on the rear of the unit

power consumption

less than 35W

dimensions(including feet, terminals and controls)

445mm wide
75mm high
338mm deep

The rated and typical performance applies when the mains supply voltage is either 230V AC for 220 – 240V units, or 115V AC for 110 – 120V units Your T32R meets or exceeds the following legal requirements:

directives

89/336/EEC	EMC Directive (as amended by 93/23/EEC)
73/23/EEC	Low Voltage Directive (as amended by 93/23/EEC)

We reserve the right to alter design and specification without notice.
Specification may vary for different countries.

Reviews

Specifications

White Paper

Brochure